Adding Areas Together; Measuring Volumes - Powerfix KH 2927-1 Bedienungsanleitung

Adding areas together

1. Measure an area as described in the section
"Measuring areas".
2. Press and hold down the MODE 9 button.
"M+" appears in the display w. The area measured is
now saved.
3. Press the MODE 9 button. The device is now ready
for the second measurement.
4. Measure the next area.
5. Press the RECALL 5 button. A "+" appears in the display.
6. Press and hold down the RECALL 5 button. In the lower
line is shown the result of the first measurement.
7. Press the RECALL 5 button. Both measurements will be
added and the result is shown in the lower line.
8. Repeat steps 2. to 7. to add further measurement values.
9. If you want to exit the addition mode press the
MODE 9 button. All values will be deleted.

Measuring volumes

1. Switch the device on by pressing the ON/OFF 0 button.
2. If necessary, press the MODE 9 button several times
until the indicator
in the display w. The bar for the first part of the
measurement blinks.
3. Press the READ q button to measure the length.
The bar for the second part of the measurement blinks.
4. Press the READ q button to measure the width.
The bar for the third part of the measurement blinks.
5. Press the READ q button to measure the height.
The measured height appears in the upper line.
The height is shown in the upper line, the volume in
cubic meters (m
is shown in the lower line.
L
W
(volume measurement) appears
H
3
), as the sum of all three measurements,
- 8 -