Getting Started With The Transmitter; A) Inserting The Batteries/Rechargeable Batteries; B) Charging The Rechargeable Batteries For The Transmitter - ModelCraft 20 70 11 Bedienungsanleitung



10. Getting started with the transmitter

In the operating instructions, the numbers in the text always refer to the figure opposite or the figures
within the section. Cross references to other figures are indicated with the respective figure number.

a) Inserting the batteries/rechargeable batteries

For the power supply of the transmitter you will need 8 alkaline batteries
or rechargeable batteries mignon size (AA). For ecological and also
for economical reasons it is recommended to use rechargeable
batteries, since they can be recharged in the transmitter via a built-in
charging socket. To insert the batteries or rechargeable batteries,
proceed as follows:
The battery compartment lid (1) is located on the rear side of the
transmitter. Please press the corrugated area (2) and push off the lid
downward.
Insert the 8 batteries or rechargeable batteries into the battery
compartment. Pay attention to the correct polarity of the cells.
Afterwards slide the lid of the battery compartment back on and let
the locking mechanism click into place.

b) Charging the rechargeable batteries for the transmitter

During the operation with rechargeable batteries you can connect a
charging cable to the charging socket (1) and charge the rechargeable
batteries in the transmitter when the transmitter is switched off. It is
very important that you pay attention to the correct polarity of the
connector plug. The inner contact of the charge socket has to be
connected to the plus connection (+) and the outside contact to the
minus connection (-) of the charger.
The charging current should be approx. 1/10 of the capacity value of
the inserted rechargeable batteries. For rechargeable batteries with a
capacity of 2000 mAh this corresponds to a charging current of approx.
200 mA and charging time takes approx. 14 h.
In order to avoid damage to the internal circuit paths and connections, please don't use fast chargers.
Since a protective diode is integrated in the transmitter, no chargers can be used that briefly interrupt the charging
current in order to measure the current rechargeable battery voltage. In this case, the rechargeable batteries must be
removed from the transmitter.
30

15. Limitation de la course de pas général pour vol normal/3D
Pour limiter la course de pas général et ainsi l'incidence de vos pales
de rotor, elle peut être réglée séparément pour le mode normal et le
mode 3D.
Le régulateur de compensation de gauche «PZT» (fig. 7, pos. 1) limite
ici la course de pas général en mode normal.
Veillez à cet effet à ce que l'interrupteur correspondant de votre
télécommande (fig. 1a, pos. 11) soit aussi en position mode normal
(«NOR») pendant le réglage.
Tourner le régulateur de compensation dans le sens des aiguilles d'une
montre augmente la course de pas général. Une rotation dans le sens
contraire des aiguilles d'une montre le réduit.
Le régulateur de compensation de droite «PLT» (fig. 7, pos. 2) limite ici la course de pas général en mode 3D.
La rotation est effectuée de la même façon que celle du régulateur de compensation du mode normal.
L'interrupteur correspondant de votre télécommande (fig. 1a, pos. 11) doit être en mis en mode 3D («IDLE»).
Fig. 2a
Attention :
Les modifications des deux régulateurs de compensation ne peuvent être effectuées que si l'interrupteur
de sécurité (fig. 1b, pos. 5) est en position «UNLOCK»).
Une fois la modification terminée, remettez l'interrupteur sur «LOCK». Les réglages ne peuvent plus
être modifiés involontairement.
Fig. 2b
Fig. 3
Figure 7
55