Adjusting the Lateral Alignment
The lateral alignment of the laser beam can be
adjusted within a range of r 15 %.
The standard indication (see "Standard Indication of
the PipeLaser", page 30) displays the lateral align-
ment.
The laser beam is vertically aligned (no deviation left
or right from the axis centre) when the arrow symbol is
indicated in the centre.
Note: When the possibility of changing the setting
was locked (see "Locking Settings", page 32), lateral
alignment is not possible.
The lateral alignment can be adjusted as follows:
– Rolling Entry
Briefly press button 19.1 or 19.2:
The laser beam is deflected in small steps to the
left or right.
Press and hold button 19.1 or 19.2:
The laser beam is deflected to the left or right with
increasing speed.
or
– Rapid-setting 0 % Lateral Alignment
Press buttons 19.1 and 19.2 at the same time.
The lateral alignment is set to zero.
Note: Analogue to the measuring tool, lateral align-
ment adjustment can also be carried out with the
remote control.
Locking Settings
The settings for grade and lateral alignment can be
locked.
– Button 22 allows for settings to be locked "
enabled "
".
The standard indication (see "Standard Indication of
the PipeLaser", page 30) displays the set function.
Note: Analogue to the measuring tool, locking set-
tings can also be carried out with the remote control.
32 | English
PipeLaser Menus
The measuring tool can be configured with the menus.
– Press button 18.
The main menu is displayed.
– Select a submenu with buttons 19.1/19.2 and
20.1/20.2.
The selected submenu point is indicated by an
arrow symbol on the side.
Additionally, the name of the submenu is display in
the respective system language in a line below the
menu symbols.
– Press button 21 to call up the desired submenu.
Note: Submenus can be protected against unauthor-
ised access (" " symbol next to the submenu). Ena-
bling is possible only via the "SECURITY" submenu or
by entering a password.
Also see "SECURITY" Submenu, page 34.
Entering a Password
When a submenu is password-protected against
unauthorised access, the password must first be
entered after calling up the submenu.
* * * *
0
1
2 3 4 5 6 7
The available numbers are shown at the bottom of the
display; the placeholders for 4 numbers are shown at
" or
the top.
– Select a number with buttons 19.1 or 19.2.
– Press button 21 to set the selected number at the
current cursor position in the display.
The cursor automatically advances to the next
number position.
As soon as all 4 numbers of the password have been
entered, the submenu is called up.
Entering a false password deletes the entry and you
are prompted to enter the password again.
Pressing button 18 will display the main menu again.
8
9
2 610 A15 123 • 4.8.09