Cleaning And Maintenance; Troubleshooting; Technical Specifications - HQ Power VDPL300ME Bedienungsanleitung

8. Cleaning and maintenance

• All screws should be tight and free of corrosion.
• The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections ...
• Mechanically moving parts must not show any signs of wear and tear.
• The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
• Regularly remove dust from the housing and the air vents using a slightly damp cloth.
• There are no user-serviceable parts inside. Refer to an authorized dealer for service and/or spare
parts.
Fuse Replacement
• Wedge the fuse holder out of its housing with a flat-head screwdriver.
• Remove the damaged fuse from its holder and replace with exact same type of fuse.
• Insert the fuse holder back in its place and reconnect power.

9. Troubleshooting

problem
fuse keeps blowing
chase is too slow
fixture has no power
fixture is not responding
fixture is powered on but
there is no movement to the
audio
light will not come on after
power failure
signal loss

10. Technical specifications

power supply
fuse
power consumption
DMX control
DMX connection
LEDs
beam angle
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
14.10.2011
VDPL300ME
check total load placed on fixture
check user manual for speed adjustment
check for power on mains
check fixture's fuse
check DMX settings for correct addressing
check DMX cables
check DMX indicator on display
check audio mode on the display
adjust sound sensitivity knob
check fuse
use DMX cables only
install terminator
keep DMX cables separated from power cables or blacklight
230 VAC / 50 Hz
2A / 250Vac
95 W
8 channels
3-pin XLR in-and output
256pcs (64pcs of each color)
36°
305 x 275 x 280mm
3 kg
7
possible solution
©Velleman nv