Power Connections And Startup - Eaton 9910-P65 Installationsanleitung

INSTALLATION

Power Connections and Startup

The device power cord connection(s) determines if the setup can
provide dual-redundant power to the protected device(s). See Figure 16
for a non-redundant powered device; Figure 17 shows a dual-redundant
powered device.
1.
18
EATON Powerware
Legend (Figure 16 and Figure 17)
UPS to utility (mains) power cord
1
PDU to UPS power cord
2
PDU to utility (mains) power cord
3
Mains
Figure 16. Connecting One PDU (Non-Redundant) to UPS
UPS
1
Mains
Figure 17. Connecting Two PDUs (Dual-Redundant) to UPS
If you are installing a UPS and non-redundant power to the device(s)
is desired, plug the PDU power cord into the UPS output receptacle
(see Figure 16) using the supplied power cord.
If you are installing a UPS and dual-redundant power to the
device(s) is desired, two PDUs are required. Plug the first PDU
power cord into the UPS output receptacle (see Figure 17) using
the supplied power cord. Then plug the second (redundant) PDU
power cord into a non-UPS protected output receptacle (mains) or
into a second UPS.
®
5125 (9910-P65) UPS Installation Guide for IBM
PDU
UPS
2
1
PDU PDU
2
® S
Applications 164201638 Rev A
TVSS Protected or
Second UPS
3
Mains