Standby; Mirror Function; Video Input Selection - Conrad Electronic 75 15 92 Bedienungsanleitung

The monitor might take up to 3 seconds to start up and display a picture on the
screen (1).
• Remove the protective battery foil of the remote control
as illustrated to the right (if it has not been removed at
delivery).

10. Standby

Once the monitor has been switched on by pressing the ON/OFF button (8) it can be put into standby
mode using the remote control.
Press the "Standby" button (11) on the remote control.
During standby the "Standby" LED is red.
Press the "Standby" button (11) again to end standby mode.
Please note that pressing the "Standby" button (1 1) will not turn on the monitor if it
has been switched off with the ON/OFF switch (8).

11. MIRROR function

If the monitor is to be mounted on a wall or ceiling, the display might have to be flipped or rotated by
180°. The monitor offers 4 different displays.
To adjust the display, press the MIR button (13) on the remote control or the MIR button (4) on the mon-
itor until the display is set as desired.

12. Video input selection

The monitor offers two video inputs to be connected to yellow (video input 1) or black (video input 2)
plugs (also see chapter "9.1 Explanation of connector plug colours").
Press the "V1/V2" button (15) on the remote control to switch between video inputs AV1 (video input 1,
yellow plug) and AV2 (video input 2, black plug).
28