Handling Your Stored Data; Menu Structure; Infrared Interface - Mettler Toledo SevenGo pro SG8 Bedienungsanleitung

Handling your stored data

4.7 Handling your stored data

4.7.1 Menu structure

To access the memory, press the Data softkey.
1. Meas. Data
1. Review
2. Transfer
1. Partial
2. All
3. Delete
1. Partial
2. All
2. Cal. Data
1. pH
1. Current
2. 5 latest
2. Ion
1. Current
2. 5 latest

4.7.2 Infrared interface

With SevenGo pro™ it is possible to transfer either all data or a user defined set of data from the memory
to a METTLER TOLEDO RS-P42 printer or to a PC. The data is transferred via the IR interface on the left side
of the meter.
The following descrpitions describes how to proceed with the different configurations:
- Data transfer from SevenGo pro™ to an RS-P42 printer is done using an IR-RS232 adapter
(51302333). To prepare for data transfer connect the RS232 plug to the corresponding interface on the
backside of the printer. Point the instrument's IR window toward the IR receiver on the other end of the
adapter cable. Start data transfer in the data menu.
- For data transfer from SevenGo pro™ to a PC, there are three different possibilities:
- direct transfer via an IrDA interface on your PC
- transfer via IR-RS232 adapter (51302333)
- via IR-USB adapter (51302332) �
Install the driver software (the latest drivers required to configure your PC can be downloaded from
www.mt.com/pHLab).
Open Hyperterminal or BalanceLink. Adjust the settings for data transfer as follows:
Baud rate: 1200 IR-USB / 9600 IR-RS232
Data bits: 8
Parity: none
Stop bits: 1
Handshake: none
Connect the adapter to the PC and/or point the IR window of the meter to the IR receiver. Start the data transfer
by selecting the transfer item in the data menu.
18
(Enter measurement database)
(Review data)
(Transfer data)
(Set parameter to transfer part of data from memory)
(Transfer all data from memory)
(Delete data)
(Set parameter to delete part of data from memory)
(Delete all data from memory)
(Enter calibration database)
(Review/transfer current calibration data)
(Review/transfer 5 latest calibration data)
(Review/transfer current calibration data)
(Review/transfer 5 latest calibration data)
METTLER TOLEDO SevenGo pro™ pH