PROGRAMMING PASSPORT
INTELLIGENT DOG
™
DOOR
The default factory settings programmed for your Dog Door can be customised to work for you and your pet(s) . Programming the Dog Door can be
done by using the door Control Panel or the Dog Door Computer Application . To use the Computer Application, please see "Connecting Dog Door
to Computer" .
Main Menu
This is the default screen on the Dog Door . Also if navigating a lower level menu, the screen will time out and return to Main Menu if there is no
activity after two minutes . After five minutes of no activity, the LCD Screen will go to sleep (like a mobile phone or computer) . To wake the LCD
Screen and return to Main Menu, push any key on the 5-Button Navigation .
Setup: Allows you to change door settings for the Dog Door including door operational mode, keypad lock,
Volume, date/time, Low Battery Mode, and language . Also allows changes to pet settings including pet access
mode, Re-latch Time, In-Tone/Out-Tone, adding a pet, removing a pet, renaming a pet, and relearning a pet .
Below Setup each of the successfully programmed pets are also displayed along with each pet's location
(based on when the Dog Door was last accessed while in Smart Mode) . When a pet is selected from this list, a
history of the last 4 dates and times the pet accessed the Dog Door while operating in Smart Mode is displayed .
DOOR SETTINGS
The Door Settings screen allows you to customise the door operation and settings of the Passport
™
Intelligent Dog Door .
To open the Door Settings menu, from the Main Menu select Setup > Door Settings . The Door Settings screen displays the following options:
Door: Allows Dog Door operational mode to be changed with three mode
options: Smart Mode (default factory setting), Open or Locked .
Lock Keypad: Allows the 5-Button Navigation to be disabled by setting a
4 digit PIN number .
Volume: Turns the Volume on or off for the audible beeps and sounds (such
as In-Tone and Out-Tone) . Default factory setting for Volume is On .
Date/Time: Sets the date and time used by the Dog Door .
Low Battery Mode: When powered by Passport
Rechargeable Battery,
™
allows the door flap to be set to the Open or Locked position when battery runs low and door shuts down with an optional audible beep . Default
factory setting is Off for beep and Locked for flap shut down position .
Language: Allows the current language to be changed . Default factory setting for language is English .
Door Operational Modes
The Dog Door has three operational modes: Smart Mode, Open, and Locked .
Smart Mode: Allows any dog with a programmed Passport
Key to access the Dog Door as programmed for that specific pet . This is the default
™
factory setting .
Open: Allows the flap system to remain unlocked so any pet or animal can enter or exit, even pets NOT wearing a programmed Passport
Key .
™
The Dog Door will function like a traditional dog door in this mode . Access Modes, In-Tone, Out-Tone, Pet Location, and Pet Tracking are disabled
in Open Mode .
Locked: Shuts and locks the flap system so no pet can enter or exit, even if wearing a programmed Passport
Key .
™
To Change Door Operational Mode:
www.petsafe.net
3