Inhaltsverzeichnis
Werbung
You should be able to see a list of AT commands similar to the one as shown below. This
means that your modem is successfully installed.
Click OK.
SmartUSB56 Modem
If your modem is not installed properly, the set of AT commands will not be listed. You may also be
prompted by an error message, stating that it was unable to open the COM Port. If this happens,
i)
make sure that there is no communication software (e.g. HyperTerminal, Dial-Up Networking, etc)
running.
ii)
from the Windows desktop, right-click My Computer. Select Properties. Click on Device
Manager tab. Check whether there is any yellow exclamation mark on the Modem device. If
yes, remove and re-install the modem device. (See Section 7: on Uninstalling the Modem
Driver for Windows
Version 1.10 All specifications and information are subject to changes without prior notice
SmartUSB56 Modem
98 SE / Windows
Me.)
®
®
Typhoon RedFun V.92 56K USB Modem
Article Number: 51303
(The information shown here may differ
from what you see in your computer.)
15
Werbung
Inhaltsverzeichnis
