Werbung
Insert the other end of the connection
cable into the input jack (6) on the trans-
mitter.
Amplifier
24
black
negative, left loudspeaker output
connect with
housing earth
Connecting the receiver
The loudspeakers are directly connected to the SPEAKER OUT loudspeaker
connection terminals (2) of the receiver.
The loudspeakers have to be connected with two-wire leads.
Insulate the bare wires at the connecting terminals. Make sure
that there are no sharp edges which could damage the cables.
Only use loudspeakers which have a sufficiently high loading
capacity (see "Technical Data").
Connect the loudspeakers directly with the receiver.
Do not use headphone adapters or distributing boxes! If you are
unsure about anything please contact a specialist.
Make sure that the loudspeakers have been connected in the cor-
rect polarity, i.e. that the plus and minus signs match up!
The connection cables of the loudspeaker boxes are normally
coded:
Some loudspeaker manufacturers indicate the (+) wire by means
of an additional colour stripe, others use a corrugated cable for
the (+) terminal and a smooth one for the (-) terminal.
The receiver has been built for a loudspeaker impedance of at
least 4 Ohm on each channel. Never connect loudspeakers with a
lower impedance.
Connect the SPEAKER OUT (2) loud-
speaker connection terminals to the
loudspeakers as follows:
L+
positive connection of the left loudspea-
ker.
L-
negative connection of the left loud-
speaker.
R+
positive connection of the right loud-
speaker.
R-
negative connection of the right loud-
speaker.
25
Werbung
Kapitel
