Werbung
left loudspeaker
Receiver
26
right loudspeaker
Take care not to place your devices in direct sunlight and protect
them from vibration, dust, heat, cold, and moisture.
Only operate the system on a sturdy, flat surface that does not
react adversely to warm temperatures.
Carelessness in following these instructions could lead to the
system becoming damaged.
Place the system in a stable position, away from objects that
might might fall on it, avoiding unwanted accidents.
Set up the transmitter near the audio amplifier, and close to a wall outlet.
Set up the receiver near the audio amplifier near the loudspeakers to be connected,
and close to a wall outlet.
Alternatively, the transmitter also can be set up normally on the housing feet with the
accompanying base stand. For this purpose, insert the base stand into the opening
slit on the rear side of the housing.
Connecting the transmitter
The transmitter with the accompanying connection cable is connected to the louds-
peaker outlet of the audio amplifier.
Only use the special cables included with the delivery to connect
the input.
To avoid distortion or mismatching which could damage the device,
only loudspeaker outlets of audio amplifiers may be connected to
the transmitter input.
If you are unsure about anything please contact a specialist.
Connect the green cable to the earth of
the amplifier housing.
Connect the other cables as follows:
Audio amplifiers are usually delivered
with a terminal screw for connection to
the earth of the record player. If this is
not the case, the cable lug on the green
cable can also be attached to a housing
screw.
orange
positive, right loudspeaker output
yellow
negative, right loudspeaker output
red
positive, left loudspeaker output
23
Werbung
Kapitel
