Topcom Twintalker 1300 DUO COMBI PACK Bedienungsanleitung Seite 7

When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries need to be
replaced or recharged.
12 USING THE TWINTALKER 1300
12.1 TURNING THE UNIT ON/OFF
• To activate; press and hold
• To switch off; press and hold
12.2 ADJUSTING SPEAKER VOLUME
The Speaker Volume can be adjusted using
SC
TX RX
12.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
SC
TX RX
12.4 TRANSMITTING A SIGNAL
• Press and hold
SC
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
TX RX
• Release
12.5 CHANGING CHANNELS
The PMR has 8 available channels.
To change channels:
• Press
SC
• Press
• Press
PTT
TX RX
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
12.6 MONITOR
You can use the MONITOR feature to check for weaker signals in the current channel.
• Press button for normal monitoring .
TOPCOM TWINTALKER 1300 DCP
Dispose of batteries at a designated battery disposal unit and
not in the household waste. Do not short-circuit & dispose of in
fire. Remove the batteries if this device is not going to be used
for a long period.
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
In order for other people to receive your transmission, they must be set
on the same channel.
to TRANSMIT.
PTT
when you have finished transmitting.
PTT
once, the current channel number flashes on the LCD Screen.
or to change the channel.
to confirm the channel selection and return to NORMAL mode.
TOPCOM TWINTALKER 1300 DUO COMBI PACK
/ . The Speaker Volume level is displayed on the LCD.
7