Symbols On The Machine; Safety Devices - Metabo KS 216 M Lasercut Originalbetriebsanleitung

proper function as specified. Check
to see that all moving parts work
properly and do not jam. Make sure
that all parts and accessories are
properly installed and safely se-
cured to ensure the safe and trou-
ble-free operation of the machine.
Do not use damaged or warped saw

blades.
 Damaged protection devices or
parts must be repaired or replaced
by a qualified specialist. Have dam-
aged switches replaced by a service
centre. Do not operate tool if the
switch can not be turned ON or
OFF.
 Keep handles free of oil and grease.
A
Risk of injury by noise!
 Wear hearing protection.
For reasons of noise protection do

not use warped saw blades. A
warped blade is exiting vibrations to
an especially large extent, which
means noise.
A
Laser radiation hazard!
A laser beam can cause serious eye in-
jury.
Never look into the laser outlet.
A
Danger from blocking work-
pieces or workpiece parts!
If blockage occurs:
1. Switch machine OFF.
2. Unplug mains cable.
3. Wear gloves.
4. Clear the blockage using a suitable
tool.
3.3

Symbols on the machine

A
Danger!
Disregard of the following warnings
could lead to serious personal injury or
material damage.
Symbols on the machine
24
25
26 27 28
24 Warning: Laser radiation
Class 2 laser: Do not stare into
beam!
25 TÜV-tested safety (230V only)
26 Hazardous area warning
27 Do not reach into saw blade area
28 Do not operate tool in moist or
wet environment.
29 Read operating instructions
30 Wear safety goggles and hearing
protection.
Information on the nameplate:
31
32
33
34
36 37 35
31 Manufacturer
32 Article number and serial number
33 Machine designation
34 Motor specifications (see also
"Technical Specifications")
35 Date of manufacture
36 CE-mark – This machine conforms
to the EC Directives as per Decla-
ration of Conformity
37 Waste disposal symbol – Device
can be disposed of by returning it
to the manufacturer
38 Dimensions of permissible saw
blades
3.4

Safety Devices

Retractable blade guard (39)
The retractable blade guard protects
against unintentional contact with the
saw blade and from chips flying about.
29 30
Safety lock (40)
The safety lock blocks the retractable
blade guard: the saw blade remains
covered and the sawhead cannot be
lowered unless the safety lock is disen-
gaged by pushing it to the side.
Fence (41)
The fence keeps the work piece from
moving while it is cut. The fence must
always be installed when sawing.
38
The additional extrusion (42) on the
fence can be moved for cutting longer
workpieces after the lock screw has
been loosened (43):
ENGLISH
39
40
41
19