Operating Your New Appliance - Sage the No-Mess Waffle BWM520 Kurzanleitung

OPERATING YOUR NEW APPLIANCE

Before first use, remove and safely discard any
packing material, promotional labels and tape
from the waffle maker.
1.
Wipe the waffle maker cooking plates with
a damp sponge or cloth. Dry thoroughly and
close the lid.
2.
Place the waffle maker on a flat, dry surface.
Ensure there is a minimum distance of 20cm
of space on all sides of the waffle maker.
Do not place anything on top of the
waffle maker.
3.
Unwind the power cord completely and insert
the power plug into a grounded 220–240V
power outlet.
4.
Turn the POWER / DARKNESS Control Dial
clockwise to the desired setting to start
pre-heating the waffle maker. The POWER
light will be illuminated.
5.
Use the POWER / DARKNESS control dial to
adjust the brownness of your waffle. There are
7 darkness settings ranging from 1 (lightest)
to MAX (darkest). Rotate the dial clockwise
to increase the brownness or counterclockwise
to decrease it.
6.
Once the waffle maker has completed
preheating, three audible alerts will sound
and the READY light will illuminate.
7.
Open the lid and pour approximately 125ml
of batter evenly on the center of the waffle
plate. The batter should cover the peaks of
the waffle plate.
NOTE
When using the waffle maker for the first
time you may notice a fine smoke haze.
This is caused by the initial heating
of some of the components and is not
a cause for concern.
8.
Close the lid but keep the locking latch open.
As the cooking cycle progresses the READY
light will switch off.
9.
At the end of the cooking cycle, three audible
alerts will sound and the READY light will
illuminate. Open the lid and carefully remove
your waffles.
NOTE
There can be slight variations between
cooking cycles. If your waffles are not at
your desired darkness, close the lid and
cook for an additional minute.
10.
For the most consistent results, add the next
batch of batter immediately after removing the
cooked waffle and repeat steps 7 through 8.
NOTE
If the next batch of batter is not added
immediately after removing the cooked
waffle, close the lid and allow the waffle
maker to properly reheat (the READY light
will switch off and then back on) before
adding batter.
11.
If you are not cooking any more waffles,
turn the POWER / DARKNESS control dial
to the OFF position.
EN
5