Power The Radio - PERFECTPRO CUBI 2 Bedienungsanleitung

Power the Radio

A. Battery Operation
1. Installing the batteries, first pull out the battery compartment
locker to release battery compartment following the diagram
shown on the right. There are the main battery pack compartment
and the back up battery compartment.
Note:
Before you insert the batteries, if you use non-rechargeable bat-
teries, make sure the NiMH/NiCad/Alkaline switch which located
inside the battery compartment is switched to Alkaline position.
If you use rechargeable batteries, make sure to switch NiMH/
NiCad/Alkaline switch to NiMH/NiCad position.
2. Insert 6 x D size (UM-1) battery into the compartment. Ensure
the battery is inserted in accordance with the diagram shown on
page 0.
3. Insert 2 x AA size (UM-3) battery into the back up battery
compartment.
Note:
The back up battery is for time and memory station back up during
power failure. It is suggested to replace the back up battery every
six months to avoid battery leakage.
Run time of the radio on batteries varies strongly depending on
quality and capacity (mAh) of the batteries, temperature, volume
level etc.
9