Charging The Flight Battery - Reely Slow Flyer II Bedienungsanleitung


10.

Charging the Flight Battery

The flight battery is charged with the remote control transmitter.
For this, push the triangle of the charging chute flap (1) on the
back of the transmitter and push the flap open towards the right.
Then push the flight battery (2) into the charging chute to the
stop from the right. The two guide rails of the battery (3) must
point up so that the battery is connected in the correct polarity.
When the battery was pushed into the charging chute correctly
and the plug connector of the battery (4) has establishes a contact
in the charging chute, the charge control lamp (see figure 1, item
10) lights up and signals correct charging.
When the charge control lamp goes out after about 40 minutes,
charging is completed and the battery must be removed from the
charge cable.
Then push the charging chute lid open again and let the locking
tab latch.
The transmitter does not have to be switched on for charging. If the transmitter batteries grow too weak for
proper charging, the charge control lamp will grow dimmer. You may switch on the transmitter briefly during
charging for test purposes. If the red function control lamp flashes and the transmitter issues warning sounds
in a quick sequence, the batteries are already too weak for proper charging of the flight battery.
Charging duration depends on the remaining charge of the flight battery and the quality or residual capacity
of the transmitter batteries used; it may therefore vary strongly.
Attention, important!
Remove the charged battery from the charging chute without delay and do not leave it in the chute for an
unnecessarily long time!
Charge the flight battery only with the help of the remote control transmitter and do not use any chargers that
are not suitable for single-cell LiPo batteries.
Charging will only start for rechargeable batteries with a remaining capacity of less than 90%.
38
Figure 4