Operating Instructions; Connections; High Pressure Hose; Water Connection - Alto 44C3KA Betriebshandbuch

3.0 Operating instructions

3.1 Connections

1.

High pressure hose

The high pressure hose with imprinted max. working pressure and temperature should be attached to the
quick coupling (1) on the front of the machine.
2.

Water connection

Let water run through the inlet hose to remove any impurities.
Min. water supply - see section »1.2 Technical data«.
With hot water and high pressure hoses of more than 10 m the machine should be fitted with a water tank.
This also applies if the outlet of the machine is connected to a pipeline.
If there is a risk of running sand in the inlet water (i.e. from your own well), a filter should be mounted.
NOTE: Connection to the public mains according to regulations.
3.

Mains power connection

Check voltage, fuse, cables and extension cables according to section 2.1.
In countries, where many different types of plugs are applied, the machine is delivered with an electric
cable without plug. The plug should be mounted by a qualified electrician.
6
Max. length of extension hose: 50 m
Only use ALTO high pressure hose
1
1
Min. length of hose: 6 m. 3/4"
Clean water inlet filter (1) at monthly
intervals
Max. water pressure 10 bar
Only connect to an approved socket with
earth connection.
GB