Connection And Control Elements - Renkforce MS-1239 Bedienungsanleitung

• Do not place open flames such as burning candles on the device.
• If you have doubts about how the equipment should operate or about how to safely connect it, con-
sult a trained technician.
• Never leave the device on without supervision.
• Only use the appliance in a moderate climate, and avoid a tropical environment.
• Do not leave packing materials unattended. These may become dangerous playing material for chil-
dren.
• You should also heed the additional safety instructions in each chapter of this instruction.
• Also observe the safety and operating instructions of any other devices that are connected to this
device.
• If you are not sure how to connect the device correctly or if questions arise which are not covered by
the operating instructions, please do not hesitate to contact our technical support or a specialist.

Connection and Control Elements

See illustrations on the fold-out page
(1) POWER Button
This button switches the device on and off, that is, into STAND-BY mode.
(2) STAND-BY Indication Light
The STAND-BY light is illuminated whenever the device is on STAND-BY mode.
(3) IGG TUNNING/SKIP buttons DDI
CD/CARD-USB: In CD/CARD-USB mode, the keys are used for selecting titles. By holding down one of
the buttons during playback of the CD, specific section of the title can be found.
Radio: In radio mode, the keys are used for selecting the incoming frequency. Pressing one of the keys
for more than 1 second starts the automatic station search.
(4) STOP Button
This button stops CD playback (CD/CARD-USB).
35