Troubleshooting - Carrera RC Ferrari Boat Arno XI Montage- Und Betriebsanleitung

• After sailing it, clean the Carrera RC boat carefully
• Always recharge the battery immediately after use to prevent its becoming deep
discharged.
• Always keep the Carrera RC battery stored outside the boat.
Controller functions
1
ON
OFF
2
3

Troubleshooting

Problem Cause
Either the switch on the controller or the boat is set to OFF.
Boat does not move
There is no rechargeable battery in the boat or the battery is too
weak.
The overheat protection has caused the boat's motor to cut out due to
excess temperature.
The battery or rechargeable battery in the transmitter or boat is too
weak.
The boat is very warm.
The controller is possibly not correctly connected with the receiver in
the model.
Boat cannot be controlled Boat starts moving unintentionally.
For the latest version of these operating instructions and information on replacement and spare parts available, please visit
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
When the controller is switched on,
the red LED lamps at the front of the
controller are lit.
Steering digital proportional
Gas pedal to the rear: forwards
Gas pedal to the front: braking,
or backwards
Please also note that, due to the "turn-
ing effect", the steering radius of a left-
hand curve is greater than that of a
right-hand curve.
The 2.4 GHz controller is suitable for
left- or right-handers and can be
adjusted as necessary by unscrewing
and refixing the steering unit accord-
ingly.
4
5
6
7
Solution
Switch on.
Insert charged battery.
Switch off the receiver.
Leave the RC boat to cool down for approx. 30 minutes.
Insert new battery or recharged battery.
Allow the RC boat to cool down for about 30 minutes.
Establish contact between model and controller as described under
"Connecting the model with the controller".
First turn on the transmitter, only then the boat
Please replace the batteries in the controller or switch the controller on.
carrera-rc.com
11
Function can be changed by
remounting the steering unit
To remount, unsrew the three screws on
the inside of the steering unit and screw
them to the opposite side.
Remove the cover plate from the other
side and mount the steering wheel to
the opposite side. Insert and tighten the
three inner screws again. Finished!
TH-TRIMM
Fine speed regulation
Here you can adjust the braking effect
on your boat.
TRIMM-steering
Fine steering adjustment
If the boat does not run in a straight
line, you can make fine steering adjust-
ments here.
Range control
On leaving the radio frequency, the boat
automatically returns to within range
radius.
On sailing out of range of the radio
signal, or with empty batteries in the
controller, after about 5 seconds the
boat will start to describe small, ever-
widening circles in order to regain radio
contact.
.
in the service area.