Power Supply - Duravit SensoWash Starck Bedienungsanleitung

3.3 Power supply

• Connect the SensoWash
connected load. Use a residual-current protector.
• Make sure that the power cable and mains plug are not damaged.
• The power cable must not become jammed or pinched.
Keep the cable away from hot surfaces and sharp edges.
• Modifications to the mains plug or power cable may only be made by an expert.
• After installation, make sure that the mains plug is accessible to the user and do
not use an extension cable which is not properly earthed.
• Lay the cable so that it does not pose any risk of tripping.
• To pull the mains plug out of the electrical socket, always pull on the plug, not the
cable.
• Never touch the mains plug with wet hands.
• To disconnect the SensoWash
mains plug.
• If despite this the power cable or mains plug still become damaged, do not re-
place them yourself. They may be replaced only by a trained, authorised expert.
• Do not expose the SensoWash
• Do not use the product if it is not working properly. Disconnect it from the mains
immediately. Close the water cut-off valve to interrupt the water supply. Contact
your plumber/electrician or the Duravit customer service.
Starck only to an electrical socket with the specified
®
Starck completely from the mains, unplug the
®
Starck directly to water.
®
EN
43