Troubleshooting Guide - MSR BLADE Bedienungsanleitung

Troubleshooting Guide

Problem
Helicopter will not
initialize
Helicopter will not
spool up
Motor power decreases
during flight
Climb out rate is greatly
reduced
Poor tail authority
LED on receiver fl ashes
rapidly and aircraft will not
respond to transmitter
(during binding).
LED on receiver fl ashes
rapidly and aircraft will not
respond to transmitter
(after binding).
Helicopter vibrates or
shakes in fl ight
Helicopter spins
counter-clockwise in fl ight
EN
Possible Cause
Throttle at high position
On computer radios, switches not in
normal position
Throttle servo reversing improperly
confi gured
Low fl ight battery voltage
Receiver uses default soft Low
Voltage Cutoff (LVC)
Main gear has slipped on the main
shaft.
Tail boom is cracked
The tail rotor blade is warped
or bent.
Aircraft not bound to transmitter
Transmitter too near aircraft during
binding process
Less than a 5-second wait between
first powering on transmitter and
connecting flight battery to aircraft
Aircraft bound to different model
memory (ModelMatch™ radios
only)
Flight battery/Transmitter battery
charge is too low
Damaged rotor blades, spindle or
blade grips
Tail motor failing
Reset controls with throttle stick at low-
est position, and throttle trim at center or
lowest setting
Set flight mode to OFF/0 and switch
throttle hold off
Correct servo reversing
Refer to your transmitter manual
Completely recharge fl ight battery
Recharge flight battery or replace flight
battery that is no longer performing. Re-
place charger batteries (included charger
only).
Push main gear back up into position.
Replace tail boom
Twist rotor blade back into position
or replace.
Bind transmitter to aircraft receiver
Power off transmitter, move transmitter a
larger distance from aircraft, disconnect
and reconnect flight battery to aircraft
and follow binding instructions.
Leaving transmitter on, disconnect and
reconnect flight battery to aircraft
Select correct model memory on trans-
mitter and disconnect and reconnect
fl ight battery to aircraft
Replace/recharge batteries
Check main rotor blades and blade grips
for cracks or chips. Replace damaged
parts. Replace bent spindle.
Replace the tail motor and tail boom
12
Solution