Transporting The Appliance; Maintenance - Wolf Garten LI-ION POWER 34 Betriebsanleitung

Cut / Collect (LI-ION POWER 37, LI-ION POWER 40)
Activate cut/collect function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Do not start the motor until your feet are at a safe dis-
tance from the cutting tool.
1. Remove the grass collecting bag.
2. Turn the switch to "CUT/COLLECT".
3. Hang up the collection bag if necessary.
4. Start the motor.
Mulch (LI-ION POWER 37, LI-ION POWER 40)
„Mulching" is a process in which the grass is finely chopped by a
special cutting system and then deposited on the ground. The re-
sult is that the grass does not have to be collected and disposed
of. „Mulching" also prevents the lawn from drying out.
3
Instructions for mulching
We recommend:
z Depending on the growth of grass, mulch 1 – 2 x per
week
z The grass should not be too high nor too wet!
z Go slow while mulching
z Take care that the blade channels do overlap.
z Do not cut grass more than 20 mm.

Transporting the appliance

1
Attention!
Before transport on or in a vehicle:
z Switch off the motor and remove the contact key.
z Allow engine to cool (approx. 30 minutes).
z For transport on or in a vehicle, secure the appliance
adequately against slipping.

Maintenance

General
1
Caution! Rotating blade
Before carrying out any maintenance or cleaning work:
z Remove the contact key.
z Remove the battery.
z Do not touch rotating blades.
Cleaning
1
Caution!
Wear protective gloves.
z Clean mower thoroughly after each mowing with cloth or
brush.
z Never spray the mower with water.
z Clean the mulch flap at regular intervals with a small broom
(LI-ION POWER 37, LI-ION POWER 40)
16
U
V
.
3
Note:
Mulching is not advisable in case of moss-affected or
entangled grass, because the cut material stays on the
moss surface and/or entanglement and thus cannot be
absorbed by the ground.
z Regularly scarify and manure the lawn.
Activating the mulch function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Do not start the motor until your feet are at a safe dis-
tance from the cutting tool.
1. Remove the grass collecting bag.
2. Set the switch to „MULCH".
3. Start the motor.
1
Attention!
z First stop the engine before moving it over surfaces other
than grass.
Winter Storage
z Clean mower thoroughly before storing away.
z Have your mower thoroughly checked once a year by an ap-
proved Service Centre.
z Do not store it in a wet or humid place.
z The Lithium iron battery must also be recharged before pro-
longed periods of non-use, for example at the beginning of
winter.
U
G