Programming A Somfy Rts Garage Door Motor; Programming A Somfy Rts Gate Motorisation - SOMFY V100 Montage- Und Gebrauchsanleitung

Video door phone V100

7.2 Programming a Somfy RTS garage door motor

Note: The monitor can be disconnected from the power supply to carry out this operation.
[1]. Open the motor cover.
[2]. Check that the motor is powered on.
[3]. Select a free channel by pressing the channel selection button on the monitor.
[4]. Press the settings button
The motor settings indicator light comes on and stays on.
[5]. Briefly press the monitor opening button.
The motor settings indicator light flashes then goes off.
3
Note: To clear the programming on the video entry phone on a Somfy garage door motorisation, repeat all the steps detailed above.

7.3 Programming a Somfy RTS gate motorisation

Note: The monitor can be disconnected from the power supply to carry out this operation.
[1]. Open the cover on the control cabinet or the motor containing the electronics.
[2]. Check that the motor is powered on.
[3]. Remove the monitor from its mounting bracket.
[4]. Select a free channel by pressing the channel selection button on the monitor.
[5]. Place the monitor on the target on the motor electronic unit.
Important: The left-hand section of the monitor must be placed on the electronic unit target so that the monitor can be correctly detected by the motor
electronics.
[6]. Briefly press the monitor opening button.
The RADIO indicator lights on the motor electronic unit lights up then goes out.
4
Note: To clear the video entry phone programming on a Somfy gate motorisation, see the motorisation guide.
Copyright © 2015 Somfy SAS. All rights reserved.
on the motor and hold down for 3 seconds. The programming function is activated for 2 minutes.
4
5
6
3s
Motorisation electronic unit
5
<0,5s
< 0,5s
EN
12