Seca 684 Bedienungsanleitung Seite 23

6. Tip the scales forward and place it
onto the side piece (1).
7. Assemble the rear and front nut
together with the crown gear.
8. Tighten the three nuts using the sup-
plied socket wrench and combination
wrench. Use the supplied screwdri-
ver as a toggle in the combination
wrench.
9. Place the scales back onto the weig-
hing platform.
10. Assemble the side piece accordingly.
Tip the scales over after tightening
the middle nut.
11. Remove the adapter between the six
bolt heads and the frame weighing
platform on both sides.
12. Fasten the left (2) and right (3) side
piece covers. At each corner, fit two
countersunk bolts (4) M6 x 12 and fit
the threaded anchor plate (5).
13. Place the scales back onto the weig-
hing platform.
14. Place the handrail (6) onto the two
side elements.
15. Use the countersunk bolts M6 x 12
to fasten the handrail into place.
16. Fasten the bottom transverse bar (7)
with the M8 x 20 oval head screws
and plain washers.
Model 684
1
5
2
4
3
6
7
23
GB