Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation Instructions
1.System status
There are 4 statuses as following:
• Arm: defense zone 1~99 will alarm when detectors are triggered
• Home Arm: in arm status, the defense zone which is set as Home Arm will
alarm when detectors are triggered.
• Disarm: defense zone 1~99 will not alarm when detector triggered (except 24
hours defense zone)
• System setup status: In this status, all defense zones will not alarm when de-
tectors are triggered.
2. Remote Controller Operation
Users can use remote controller to set system as Out Arm, Home Arm, Emergency
Alarm, Real-time Disarm and etc.
• Out Arm: Press for lock button
• Disarm: Press for open lock button
• Home Arm: Press for flash button
• Emergency Alarm: Press for alarm button, system will alarm at once.
3. Out Arm
It means to guard all around your house while everyone is going out; all the detec-
tors of the host are always working; when the detector is triggered by detecting
source (anti-theft, fire prevention, gas leak, etc.), the alarm system will sound the
alarm. Press ARM button on keypad, system will make a beep per second and totally
60 beeps. The ARM indicator will be on without flashing. It means Out Arm is set
successfully.
Main unit operation: Press ARM button, the system will enter arm status 60 seconds
later or delay time set by user
Remote controller operation: Press lock button on remote controller, system will
enter OUT ARM mode immediately.
SMS remote operation: The SMS command is: Remote Control Password (Default:
1234) + [1]
After the setting, the host makes a „Di" sound, ARM LED is on and you will receive
a SMS: System armed. Note: SMS command can only be controlled by the preset
three alarm SMS numbers.
ENGLISH
20
Operation Instructions
4. Home arm
It means, for the safety, while somebody is at home, you need to enable the peri-
pheral door, window, balcony and boundary detectors of the alarm system while
prevent from triggering the indoor detectors, which may cause improper warning;
then, you shall select Arm at Home, let just part of the detectors work and disable
the other parts.
Main unit Operation: Press Home button on keypad
Remote Control Operation: Press flash button on remote controller once
5. Disarm
It means to stop the alarm when the main unit sounds the alarm or make the alarm
system in the state of non-warning. After disarming, even if you trigger the detector,
the main unit would not sound alarm (excluding 24-hour defense areas).
Use keypad to input system password (Default: 1234), then press # button. ARM or
STAY lights will be off. It means disarm setting successful.
Main Unit Operation: input system password + #
Remote Control Operation: Press open lock button on remote controller
SMS remote operation: The SMS command is: Remote Control Password (Default:
1234) + 2
After the setting, the host makes „Di" Di" sound, ARM LED is off and you will receive
a SMS: System disarmed.
6. Emergency help
Press [SOS] button on keypad, or [ ] button on remote controller or wireless panic
button, the main unit will alarm and make call to the preset user numbers.
ENGLISH
21
Werbung
Kapitel
Inhaltsverzeichnis
