VOLTCRAFT IR-1600 CAM Bedienungsanleitung Seite 42

Auto Mode
Here, permanent measuring can be switched on or off. Pushing the button "Enter" actuates the slider in the display.
I = enabled, o = disabled
The automatic deactivation functions are disabled in permanent measuring mode. Ensure that you switch off
the meter after the measurement is completed.
Max/Min
Here, the automatic display of the min and max measured values during measurement can be switched on or off.
Pushing the button "Enter" actuates the slider in the display.
I = enabled, o = disabled
Average/Dif
Here, the automatic display of the average and difference from min and max measured values during measurement
can be switched on or off. Pushing the button "Enter" actuates the slider in the display.
I = enabled, o = disabled
Ambient Temp/RH
Here, the automatic display of the ambient temperature and relative humidity can be switched on or off. Pushing the
button "Enter" actuates the slider in the display.
I = enabled, o = disabled
The sensors for ambient temperature and relative humidity are installed in the meter (14). Observe the
delayed measurement by the constructional placement of the sensors. Give the meter enough time to adjust
to the ambient conditions (approx. 30 minutes for a stable measured value).
Dew point/Wetbulb
Here, the automatic display of the dew point and the evaporation temperature (WetBulb) can be switched on or off.
Pushing the button "Enter" actuates the slider in the display.
I = enabled, o = disabled
The dew point and the evaporation temperature are calculated values that result from the IR surface temper-
ature, the ambient temperature and the relative humidity. The sensors for ambient temperature and relative
humidity are installed in the meter (14). Observe the delayed measurement by the constructional placement
of the sensors. Give the meter enough time to adjust to the ambient conditions (approx. 30 minutes for a
stable measured value).
42