[_i_dH[-']][
rl_| J[l,i
J) il i [:_,_ ITiTii
_
t, TJiT_
i'lJtJi
I_ J ] i i I.._'_I.__A_ :j
IIh [_
d i 1111 fi i |1
ill
ill
il L_
_ i i d Jl J T_
i i iii
[ JTI _
I i
Color component
output
connectors
(PR/CR, PB/CB and Y)
The red (PR/CR}, blue (PB/CB) and brightness
(Y) signals are output indepel]dently,
achievil]g
more faithful
reproduction
of the colors
• The color component
input connectors
may be marked
differently
on some TVs or
monitors
(PR, PB and Y/R-Y, B-Y and Y/CR, CB and Y, etc)
For details, refer to the W's
operating
instructions
Connect in this way if your TV is compatible
with Progressive
Scan.
To power
outlet
NOTES:
• Use the three comrnerciaEly
available
video cords to connect the DVD_gB00's
color component
output
conne_ors
to
the
[_
or
monitor
• Set the "TV TYPE" in "VIDEO SETUP" n "SETUP"
to comply with
your TV's video format
Wllen the TV
is PAL formated,
set to PAL (See page 16)
• Set the "VIDEO OUT" n "VIDEO SETUP"
i_1"SETUP"
to comply with Progressive
TV (NTSC formated
only)
• To use with
2-channel
audio output,
set "2 CHANNEL"
in "AUDIO
CHANNEL"
in "AUDIO
SETUP" in
"SETUP"
at the initial settings
(See page 17)
• Set the "TV ASPECT" in "VIDEO SETUP" in "SETUP" to comply with your W's aspect
(See page 16)
• Use the commercially
21-pi_l SCART cable to con_lect the TV's 21-pi_l SCART terminal
to the DVD-38gO's 21_
pin SCART terminal
(AVl /AV2)
To
power
outlet
NOTES:
• Some discs contain copy prohibt
signals
If such
discs
are played
via a VCR, the
copy
prohibit
system may cause disturbance
in the picture
• Set
the
"TV
TYPE"
n
"VIDEO
SETUP"
in
"SETUP"
to comply with your TV's video format
When
the TV is PAL formated,
set to PAL
(See
page 16)
• To mprove
picture quality, you ca_l change the video sig_lal output
from the AVl
terminal
from
"Video"
to
either "S-Video"
or "RG B" to suit the type of television you are using (See page 16)
• You can also connect other equipment
to AV2
Satellite
receiver
This unit
Video cassette recorder
or decoder
CONSUMERS
SHOULD
NOTE
THAT
NOT ALL
HIGH DEFINITION
TELEVISION
SETS ARE FULLY
COMPATIBLE
WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED
IN THE PICTURE
IN CASE OF 525 PROGRESSIVE
SCAN PICTURE PROBLEMS,
iT IS RECOMMENDED
THAT THE
USER
SWITCH THE CONNECTiON
TO THE "STANDARD
DEFINITION"
OUTPUT
NOTES:
• Set the DVD-3800 to the standby mode to output
video or audio signals of another device connected
to
the DVD-3800's
21-pi_l SCART terminal
(If the power is O_lr the DVD-38gO's video and audio sig_lalS are output
If the poweE is off, the signals of
the other device will not be output)
• To use the 21-pin SCART terminal,
set "AUDIO
CHANNEL"
under "AUDIO
SETUP" at "SETUP"
to r'2
CHANNEL"
7