Sage the Soft Top Luxe Kurzanleitung Seite 6

Functions
BEFORE FIRST USE
Remove any promotional material attached to
your kettle. It is recommended that before first
use, the kettle is filled to the maximum level with
cold tap water, boiled and water discarded. Your
kettle will only operate when positioned on the
power base with the 'On/Off' switch in the 'On'
position. The kettle will automatically switch off
once the water has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle, remove it from the power base
and open lid by pressing the lid release button.
Fill with the desired amount of water.
NOTE
Always fill the kettle between the minimum
(500ml) and maximum (1700ml) marks on the
water window. Too little water will result in the
kettle switching 'Off' before the water has boiled.
Filling above the maximum mark (MAX) may
result in boiling water splashing from the kettle.
Ensure the lid is locked firmly into place.
Position the kettle securely onto the power base.
Insert the power plug into a 230/240V power
outlet and switch on.
Press the 'On/Off' switch to the 'On' position
for water to boil.
NOTE
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald.
Do not pour the water too quickly.
The kettle will automatically switch 'Off' once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled to the
maximum level. To re-boil it may be necessary
to wait for up to 30 seconds to allow the control
to reset.
If further heating of the kettle is not required,
switch 'Off' at the power outlet, unplug the
power cord and empty the water from the kettle.
Replace the kettle onto the power base and
close the lid.
6
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the
appliance be operated with insufficient water.
If this occurs, the kettle will stop heating. Switch
'Off' at the power outlet and allow kettle to cool
before refilling. Remove the kettle from the
power base and add water. Return the kettle
to the power base. The safety device will then
automatically reset.
For additional safety, your kettle is fitted with
an additional thermal cut out. In the event of
overheating, the kettle will automatically shut
down to prevent further damage. Should this
occur, take your kettle to an authorized Sage
Service Centre.
®