Cleaning; Trouble Shooting; Corrective Action - FLORABEST FAT 18 B2 Betriebsanleitung

Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!

Trouble shooting

Problem
Appliance won't
start
Intermittent opera-
tion
Much vibration
Loud noise
Bad trim
Possible cause
Battery ( 16) discharged
Battery ( 16) not in
On/Off switch ( 2) de-
fective
Motor defective
Internal loose contact
On/Off switch ( 2) de-
fective
Cutting insert ( 13) bro-
ken
Trimming assembly dirty
Motor defective
Cutting insert ( 13) bro-
ken
Trimming assembly dirty
Battery ( 16) not fully
charged
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
• After every trimming session, remove
grass and soil from the protective cover
and the trimming assembly.
• To thoroughly clean the trimming as-
sembly, remove the cutting insert
( 13) (see "Replacing the cutting
insert") and use a sharp knife to clean
the pin ( 24).

Corrective action

Recharge battery (
„Charging")
Insert battery (
Send in to Service Centre for repair
Send in to Service Centre for repair
Replace cutting insert (
„Cleaning and servicing")
Clean trimming assembly (see „Cleaning
and servicing")
Send in to Service Centre for repair
Replace cutting insert (
„Cleaning and servicing")
Clean trimming assembly (see „Cleaning
and servicing")
Recharge battery (
„Charging")
16) (see
16) (see „Operation")
13) (see
13) (see
16) (see
GB
37