Zigzag Stitching; Zip Foot - Silvercrest SNMD 33 A1 Bedienungsanleitung

Zigzag stitching

Stitch width dial
5 4 3 2 1

Zip foot

A
Stitch length dial
0
B
Turn the pattern selector dial to "B".
Function of stitch width dial
The maximum zigzag stitch width for zigzag
stitching is "5"; however, the width can be
reduced on any pattern. The width increases
as you move zigzag dial from "0" - "5".
Function of stitch length dial while
zigzaging
The density of zigzag stitches increase as the
setting of stitch length dial approaches "0".
Neat zigzag stitches are usually achieved at
"2.5" or below.
Satin stitch
When the stitch length is set between "0" -
"1", the stitches are very close together
producing the "satin stitch" which is used
for making buttonholes and decorative
stitches.
Fine fabric
When sewing on very fine fabric, place a
piece of thin paper under the fabric. It is easy
to tear the paper and remove the paper after
you have finish your seam.
Stitch Stitch width Stitch length
A 2.5
The zip foot can be inserted right or left,
depending on which side of the foot you are
going to sew. (A)
To sew past the zip pull, lower the needle
into the fabric, raise the presser foot and
push the zip pull behind the presser foot.
Lower the foot and continue to sew.
It is also possible to sew in a length of cord,
into a bias strip to form a "welt".
According to thickness of fabric to set stitch
length control. (B)
Sewing basics
1~4
GB / MT 17