Maintenance - Vetus BOW5524A Bedienungshandbuch Und Einbauanleitung

Maintenance

Check the four (4) carbon brushes for wear - in normal use once
per year - with very intensive use of the bow thruster, e.g. with
hire vessels, once every two months.
- Remove the protective cover from the relay and then the
protective cover to the brushes.
- Clean the carbon brushes, the holders and the collector.
(Blow away the dust coming off the brushes.)
- Check the length of the carbon brushes and replace before
the minimum length (L min) is reached. Also check the col-
lector for excessive wear.
- The brushes can be taken out of the holders by releasing the
retaining spring.
Carbon brush Bow thruster
BP1132 1 ) 'BOW5512' (12 Volt)
BP1133 1 ) 'BOW5524' (24 Volt)
BP1134 1 ) 'BOW5512' (12 Volt)
BP1135 1 ) 'BOW5524' (24 Volt)
1 ) Art. code for a set of 4 carbon brushes.
BP1132
12 V
L
min.
BP1134
12 V
Consult with Vetus for motor types other than those given
here.
18
020522.08
020522.08.indd 18 020522.08.indd 18
Motor type
R125/3-633
R125/3-634
EC3/1,2/29
EC3/2,4/33
BP1133
24 V
= 14 mm
BP1135
24 V
The bow thruster tailpiece has long-term lubrication.
The following maintenance should be carried out during a slip-
way service:
Check the cathodic protection
and if necessary renew the
zinc anode.
Provide the bolts with a
screwlock (Loctite ® ).
Zinc anode, article code:
BP1001.
Clean the propeller shaft,
grease with 'outboard gear
grease' and refit the propeller
on the shaft.
The instructions of the manufacturer should be followed for the
maintenance of the batteries. Vetus batteries are maintenance
free.
Operation manual and installation instructions Bow thruster 55 kgf, ø 150 mm
02-03-2006 11:50:13 02-03-2006 11:50:13