Fitting The Guide Fence; Connecting The Sawdust Extraction Device; Operation; Switching On And Off - Parkside PHKSU 710 A1 Originalbetriebsanleitung

Fig. A: Changing the saw blade
4. Remove saw blade.
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the Allen key
screw/washer.
WARNING!
► The arrow on the saw blade
to the arrow showing the direction of rotation
(running direction shown on the device).
■ Ensure that the saw blade
rotational speed of the tool.

Fitting the guide fence

♦ Loosen the wing screw
fence into the guide fence slot
♦ Adjust the required cutting width using the scale
on the guide fence
baseplate (see also Fig. B).
Fig. B: Cutting width 5 cm
♦ Retighten the wing screw
PHKSU 710 A1
is carried out in the
(until it engages)
to tighten the clamping
must correspond
is suitable for the
and insert the guide
.
and the aperture in the
.
Connecting the sawdust extraction
device
♦ Push the vacuum adapter for dust extraction
onto the chip ejector
to fi x it.
♦ Connect an approved dust and chip extraction
device.

Operation

Switching on and off
Switching on:
♦ Push the safety lock-out
and keep it pressed.
♦ Press the ON/OFF switch
♦ Once the saw is running you can release the
safety lock-out .
Switching off :
♦ Release the ON/OFF switch

Setting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx. 3 mm more than the thickness
of the material. This ensures that you achieve a
clean cut.
♦ Release the locking screw
cutting depth on the cutting depth scale
and then re-tighten the locking screw

Working with the circular saw

1. Switch on the device – as described in "Switch-
ing on and off " – and then place it with the front
edge of the base plate
2. Align the machine using the guide fence
or by using a marked line.
3. Hold the machine in both hands using the
handles and saw by exerting an even pressure.
and turn it clockwise
to the left or right
.
.
, set the desired
.
on the material.
7
GB