Setting The Cutting Angle; Setting The Cutting Depth; Setting The Guide Fence; Switching The Laser On And Off - Parkside PHKS 66 Bedienungs- Und Sicherheitshinweise

Switching off:
j
Release the oN / oFF switch

Setting the cutting angle

Q
You can set the cutting angle accurately with the
help of the cutting angle scale
j
Release the wing screws / locking bolts of the
cutting angle preselector
the desired angle on the cutting angle scale
and retighten the wing screws / locking bolts.

Setting the cutting depth

Q
note: If possible we recommend that the cutting
depth is set approximately 3 mm greater than the
material thickness. This should help to ensure you
achieve a clean cut.
j
Release the wing screw on the cutting depth
setting clamp
on the scale

Setting the guide fence

Q
j
Release the wing screw
and insert the guide fence
Retighten the wing screw

Switching the laser on and off

Q
Switching on:
j
Move the laser oN / oFF switch
Switching off:
j
Move the laser oN / oFF switch
note: If the batteries are exhausted replace them
with two 1.5 V alkaline batteries LR44 (e.g. GPA 76).

Working with the circular saw

Q
1. Switch on the device as described in the section
about "Switching on and off" and then place it
Downloaded from www.Manualslib.com
.
3
.
12 b
on both sides, set
9
, set the required cutting depth
5
and retighten the wing screw.
19
of the base plate
13
into the slot
15
.
13
to setting "I".
11
to setting "0".
11
manuals search engine
first with the front edge of the base plate
against the material.
2. Align the device using the guide fence
with reference to marked­out line or by using
the laser.
3. Hold the machine with both hands by the
handles (see Fig. A) and saw the material
with moderate pressure.

Setting the speed

Q
12 b
j
Turn the wheel
(arrow marking G)
(1 = lowest speed / 6 = highest speed):
Use the general settings suggested in the following
table (information offered without liability) or adjust
the speed setting on the setting wheel
material being cut.
Material
Hard­ and softwood (solid wood)
cut longitudinally and transversely
Plywood, hard fibre board
Chipboard
8
Blockboard, laminated wood
.
14
Coated and veneered board
PVC board
Acrylic glass panels, Plexiglas
Aluminium board
Aluminium profiles
Plasterboard
Mineral wool board
Cement­bound chipboard
The circumferential speeds at minimum and maximum
rotational speeds are approx.:
Setting rpm
1 2,200
6 5,200
Preparing for use
15
to the desired speed setting
1
to the
1
Speed
setting
6
6
6
6
6
3­5
2­4
4­6
4­6
1­2
1­2
1­2
Metres/ sec
21.8
51.7
GB/MT
8
or
55