Set-Up/Wall Bracket - Nevadent DAZD 3.7 Li A1 Bedienungsanleitung

CAUTION – PROPERTY DAMAGE!
GB
The electric toothbrush may only be recharged with the supplied
►
charger. The appliance could otherwise be irreparably damaged!
Only operate the appliance with the original accessories supplied.
►

Set-up/wall bracket

NOTE
► The charger
standing if used in dry rooms.
► In damp rooms, especially in the vicinity of
water (bath), the charger
fixed to the wall to protect it from falling into
water.
1) Press the small stand on the wall bracket
from below until this releases from the wall
bracket :
4
may only be operated free-
must be firmly
2) Then pull the wall bracket
from the charger
3) Using the screw holes of the wall bracket
mark the spacing for the boreholes on the
wall. Check to ensure that there is a mains
power socket in close vicinity.
4) Before drilling the holes, check to ensure that
there are no electrical cables or water pipes
behind the markings.
5) Use a 5 mm drill bit to drill the required holes
and insert the wall plugs.
6) Affix the wall bracket
provided.
7) After you have attached the wall bracket
guide the power cable through the right or
left cut-out in the wall bracket
fication on the fold-out page). Using the guide
rails, slide the charger
bracket .
downwards
:
using the screws
(see magni-
onto the wall
DAZD 3.7 Li A1
,
,