Overheating Protection - Silvercrest STD 2200 A1 Bedienungsanleitung

♦ Once the desired temperature is reached, the brewing time will start. The
button
during the brewing time. During the set brewing time, the water runs continu-
ously through the handle into the brewing chamber
time is finished, the
signal (the
100°C). The
WARNING – RISK OF INJURY!
► Never reboil tea after it has brewed. A reaction can cause the tea to froth
up and bubble out of the spout of the appliance. There is a risk of injury
and property damage!
The appliance now enters the keep-warm mode for about 30 minutes. The keep-
warm mode only activates if the set temperature is 70°C, 80°C or 90°C. The
button
temperature, the appliance will boil the water again. If you remove the jug
from the base
will flash blue/red in alternation. If you do not place the jug
base within 5 minutes, the appliance will switch off automatically and enter
the standby mode as soon as you place the jug
the jug
and the
switches off the keep-warm mode. The brewing time is automatically reset to
0 min.
NOTE
You can also use the appliance as a kettle for boiling water.
► Always remove the permanent filter
appliance as a kettle for boiling water.
► Set a brewing time of 0 min and a temperature of 100°C. The keep-warm
mode is inactive with these settings.
► Fill the jug
water can spill out, but do fill it at least up to the MIN mark.

Overheating protection

If the appliance overheats, the overheat protection automatically switches off the
heating element inside the appliance. The
appliance no longer heats up.
The overheating protection is activated if the appliance is switched on even
though the jug
If the heating element was switched off by the overheating protection, allow the
appliance to cool down before using it.
STD 2200 A1
will light up in blue. The
button
button lights up in blue if you have set the temperature to
button will no longer be lit.
will light up red. When the water temperature drops below the set
in keep-warm mode, the mode will pause and the
back onto the base
button flashes in red again. Pressing the
no further than up to the MAX mark to ensure that no boiling
contains no or not enough water.
button will continue to flash blue
will light up in red and you will hear a
on the base
within 5 minutes, keep-warm mode continues
and brewing chamber
button flashes blue/red, but the
GB │ IE │ NI │ CY
. Once the brewing
button
back onto the
. If you place
button manually
to use the
│ 11 ■