Assembly - Sage the Nutri Juicer Plus BJE520 Kurzanleitung

Assembly

BEFORE FIRST USE
Before using your juicer for the first time, remove
any packaging material and promotional stickers
and labels. Ensure the appliance is switched off at
the power outlet and the power cord is unplugged.
Wash the filter bowl surround, Nutri Disc
cover, Froojie Disc, Froojie
®
pulp container and juice jug and lid in warm, soapy
water with a soft cloth. Rinse and dry thoroughly.
The motor base can be wiped with a damp cloth.
Dry thoroughly.
FOR USE WITH JUICE EXTRACTOR
1. Place the motor base on a flat, dry surface such
as a bench top. Ensure that the motor base is
switched OFF at the control panel, then switch
the appliance off at the power outlet and unplug
the cord.
2. Place the filter bowl surround on top of the
motor base.
3. Align the arrows at the base of the Nutri Disc
with the arrows on the motor drive coupling
and push down until it clicks into place. Ensure
the Nutri Disc is fitted securely inside the filter
™
bowl surround and onto the motor base.
, juicer
™
Insert, food pusher,
®
™
4. Place the juicer cover over the filter bowl
surround, positioning the feed chute over the
juice disc and lower into position.
5. Raise the safety locking arm up and locate it
into the two grooves on either side of the juicer
cover. The safety locking arm should now be in
a vertical position and locked into place on top
of the juicer cover.
6. Slide the food pusher down the feed chute by
aligning the groove of the food pusher, with the
small protrusion on the inside top of the feed
chute. Continue to slide the food pusher down
into the feed chute.
EN
7