Inhaltsverzeichnis
Werbung
Kitchen timer
You can use the kitchen timer to set a time of up to
99 minutes. It runs independently of all the other settings.
Setting procedure
1
Touch the 3 symbol repeatedly until the S indicator
for the kitchen timer lights up. ‹‹ lights up on the
timer display.
2
Use the + or - symbol to set the time. .
The timer starts counting down after a few seconds.
When the cooking time has elapsed
A signal sounds once the time has elapsed. ‹‹ lights up
on the timer display. The S indicator for the kitchen timer
lights up brightly. After 10 seconds, the indicator
switches off.
Changing the time
Touch the 3 symbol repeatedly until the S indicator for
the kitchen timer lights up.
Use the + or - symbol to set the time.
Automatic time limit
If a hotplate is in use for a long time without the setting
being changed, the automatic time limit is activated.
The hotplate stops heating. F and 8 flash alternately on
the hotplate display.
The display goes out when you touch any control panel.
You can make new settings.When the time limit is
activated depends on the heat setting selected (1 to 10
hours).
Basic settings
Your appliance has various basic settings. You can adapt
these settings to your needs.
Indicador
Ajuste básico
Automatic childproof lock
o b
‹ Switched off.*
‚ Switched on.
Audible signal
o c
‹ Confirmation signal and operation error signal
switched off.
‚ Only operation error signal switched on.
ƒ Confirmation signal and operation error signal
switched on.*
Automatic timer
o f
‹ Switched off.*
‚ ŠŠ Cooking time after which the hotplates
switch off.
Duration of the timer end signal
o g
‚ 10 seconds.*
ƒ 30 seconds.
„ 1 minute.
Power Management Function
o h
b = bkkk W minimum power
b. - j = from bfkk to jkkk W
j. = jfkk W maximum power
Reset to basic setting
o k
‹ Switched off.
‚ Switched on.
*
Basic setting
Accessing the basic settings
1
Switch on the hob using the main switch.
2
Press the ‚symbol within the next 10 seconds
until a beep sounds to confirm this and o b
on the hotplate display to the right of the ‚ symbol
(see illustration).
Selecting another setting
3
Press the ‚ symbol until the indicator for the
required function is displayed.
4
Then select the required setting using the + and -
symbols for the corresponding hotplate to the right of
the ‚ symbol. The new setting appears in the time
function program display.
5
Press and hold the ‚ symbol for more than 4
seconds until a beep sounds to confirm this. The
settings have been correctly stored.
flashes
31
Werbung
Kapitel
Inhaltsverzeichnis
