Brill 32 EH Hattrick Basic Bedienungsanleitung Seite 27

During installation, ensure that the
toothed washers are positioned
under the nuts and that the nuts
are at the top on the blade bar
(figure 7).
Changing the Blade Bar
Damaged blade bars must be
changed because of the lack of
balance they cause.
For safety reasons, this must
be undertaken by a service
10.Troubleshooting
General
Faults usually occur if the equip-
ment has not been handled, cared
for or maintained correctly.
The table below contains the faults
which occur most often and means
of rectifying them. If other faults
occur, please contact the service
centre authorised by the manufac-
turer or your authorised specialist
dealer.
Fault
Unusual noises,
mower rattles.
Whistling noise
(only 32 EH).
Whistling noise.
Running unevenly,
mower vibrating strongly.
Mower leaves deep tracks.
centre or authorised specialist
dealer.
Care
Dirt and grass residue is easiest
to remove immediately after
mowing. Unplug from the mains
and lay the mower on its
side. Clean with a brush and
a cloth.
Never clean the lawnmower
A
under running water, in
Warning! Repairs which
A
require technical knowledge
may only be undertaken by an
authorised engineer.
Warning! For safety
A
reasons, only use original
Brill spares or components
approved by Brill.
We wish expressly to point out that
we are not liable under product
Possible cause
Bolts on the motor, its fixings
or mower housing loose.
Foreign body blocking aerator
roller.
V-belt slipping.
Blade bar or blade damaged
(out of balance).
Blade bar fixing to motor shaft
loose.
Ground softened by water,
lawn too wet.
particular, do not use water under
high pressure on it.
Storage
Allow the motor to cool down
before placing the machine in
an enclosed space. The guide bar
can be folded together to save
space.
Warning! When folding
A
together ensure that the
cable is not bent or trapped.
liability law for damage caused to
our equipment if this has been
caused by inexpert repairs or if
components other than our original
parts or parts approved by us
have been used or if the repair
was not undertaken by an
authorised Brill service centre or
an authorised engineer.
The same applies to additional
components and accessories.
Solution
Tighten bolts.
Switch off aerator roller,
remove foreign body.
Contact specialist workshop /
service centre.
Tighten bolts for blade and
blade bar.
Have damaged components
replaced by service centre.
Allow lawn to dry, do not mow
if grass is wet.
GB
27