Important Information - Disty distybase duo plus Bedienungsanleitung

2
NOTE
Informationen

Important information

The distybase duo/duo plus/duo exant is used as a universal base station
for operating handsets conforming to the DECT/GAP standard, and for
the distybox 300/5000. A total of 8 handsets can be registered. The
distybase duo/duo plus/duo exant can be used on two analogue
telephone lines with DTMF dialling. In combination with a registered
distybox 300/5000, cordless connection of analogue terminals to the
telephone network is possible within the radio range. This "cordless
extension cable" removes the need for time-consuming cabling work for
your analogue telephones, fax machines, answerphones, door intercoms
and modem.
The distybase duo plus version also has a analogue port for wired
connection of an analogue device like fax machines, answerphones and
modem for communication with the external network. Because of limited
features accessable at the analogue port it is not recommended for usage
with analogue telephone connected.
Optional the distybase duo plus can be equipped with a power failure
circuit. In case of power failure the first line is connected directly to the
analogue port. In this way it is possible to receive incoming calls and to
make outgoing calls.
The distybase duo exant also has an SMA aerial connection for an
external aerial, in addition to the integrated aerials. This is used to
connect a DECT aerial which can extend the range of the distybase duo
exant. When using the distybase duo exant with a distybox 5000, and
depending on the aerials used and the environmental conditions, it is
possible to bridge up to 9 km, the distybox 300 can be used at a distance
of up to 50 m within buildings and 300 m in the open air.
When shipped, the distybase duo/duo plus/duo exant is set up for
operation on two analogue telephone lines conforming to the TBR 21
standard with DTMF dialling and a long flash time.
When using the distybox 300/5000, it must be set up for operation on an
ISDN line. Therefore please set parameter 40 to 2 in programming mode
of the distybox.