Hach DRB 200 Benutzerhandbuch Seite 8

Table 1 Thermometer symbols
Symbol
Startup
Turn the instrument on
N O T I C E
Do not turn the instrument off and on quickly as this can damage the instrument.
Always wait about 20 seconds before turning the instrument on again.
1. Put the instrument on a stable, level, heat-resistant surface.
2. Connect the power cord to the power plug on the back of the
instrument.
3. Connect the power cord to a power socket with earthing contact.
4. Push the power switch on the back of the instrument to turn the
instrument on.
The first time the instrument is turned on, the language selection
screen is shown. Refer to Select the language
Select the language
1. Hold down the left key and turn the instrument on.
2. Push the right arrow key to scroll through the menu. The display
goes back to the start of the menu at the end of the menu.
8 English
Description
The heating block is increasing in
temperature.
The heating block is at the selected
temperature.
The heating block is decreasing in
temperature.
on page 8.
3. When the correct language is shown, push the key for the language.
Refer to Table 2.
Table 2 Language settings
Setting Language
GB English
D German
F French
I Italian
Set the display contrast
1. Hold down the middle key and turn the instrument on.
2. Push or hold down the up and down arrow keys to change the
contrast value.
3. Push OK to save the change.
Operation
D A N G E R
Chemical exposure hazard. Obey laboratory safety procedures and
wear all of the personal protective equipment appropriate to the
chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
Routine operation
C A U T I O N
Burn Hazard. Do not put a finger in an opening in the heating block.
Close the protective cover before increasing the temperature of the
heating block, and always keep the protective cover closed during
operation.
Setting Language
E Spanish
NL Dutch
S Swedish
PL Polish