Connecting To The Input1/Output Terminals Of The Subwoofer; How To Connect - Yamaha YST-SW205 Bedienungsanleitung

I Using two subwoofers
Connect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUT
terminals of the subwoofer to the main speakers.
Right main speaker
Subwoofer
OUTPUT INPUT AUTO PHASE
2 STANDBY
+ TO SPEAKERS – – +
/MONO
+ – – +
OFF HIGH
LOW NORM REV
FROM AMPLIFIER
INPUT
1
POWER
ON
OFF
To AC outlet

Connecting to the INPUT1/OUTPUT terminals of the subwoofer

For connections, keep the speaker cables as short as
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the subwoofer or the speakers, or both of them. Make
sure that the + and – polarity markings of the speaker
cables are observed and set correctly. If these cables are
reversed, the sound will be unnatural and lack bass.

How to Connect:

Red: positive (+)
Black: negative (–)
OUTPUT INPUT
TO SPEAKERS
+ – – +
/MONO
+ – – +
FROM AMPLIFIER
INPUT
1
Speaker output
terminals
1
Loosen the knob.
2
Insert the bare wire.
[Remove the
insulation coating at
the extremity of
each speaker cable
by twisting the
coating off.]
3
Tighten the knob
and secure the wire.
OUTPUT
2
TO SPEAKERS
+ –
+ –
FROM AMPLIFIER
INPUT
1
Caution
Do not let the bare speaker wires touch each other as
this could damage the subwoofer or the amplifier, or
both of them.
<
U.S.A., Canada, Australia, China and General models
>
only
Banana Plug connections are also possible.
1
Tighten the terminal knob.
2
Simply insert the Banana Plug connector into the
terminal.
Left main speaker
INPUT
2
– +
/MONO
– +
Amplifier
*Illustration shows YST-SW205.
Subwoofer
OUTPUT INPUT AUTO PHASE
2 STANDBY
+ – TO SPEAKERS – +
/MONO
+ – – +
OFF HIGH
LOW NORM REV
FROM AMPLIFIER
INPUT
1
POWER
ON
OFF
To AC outlet
7
E-