Herunterladen Inhalt Inhalt Diese Seite drucken

Silvercrest SSB 40 A1 Bedienungsanleitung Seite 6

Vorschau ausblenden Andere Handbücher für SSB 40 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Pull the power unit out of the wall socket, ...
... if there is a fault,
... before connecting the device to the power unit,
... before you clean the device and
... during thunderstorms.
For a complete mains separation, pull the power unit
out of the wall socket. Even if it is switched off, a small
amount of power is always used as long as the power
unit is plugged in.
To avoid any risk, do not make modifications to the de-
vice. Repairs must be carried out by a specialist work-
shop or the Service Centre.
Batteries
DANGER OF EXPLOSION! Be sure to ob-
serve the correct polarity when inserting the
battery.
Clean the battery and possibly device terminals before
you insert the batteries.
Batteries must not be charged or reactivated by other
means, nor must they be dismantled, thrown into a fire
or short-circuited.
Remove the batteries from the remote control if you do
not intend to use the remote control for a prolonged
period of time, or if the battery runs out of power. The
battery might leak and damage the remote control.
Do not subject batteries to extreme conditions, e.g. do
not place the remote control on radiators or expose it
to direct sunlight. Otherwise, there is an increased
danger of batteries leaking.
If battery acid has leaked, avoid contact with the skin,
eyes and mucous membranes. In case of contact with
the acid, rinse the affected area at once with plenty of
clean water and seek medical assistance immediately.
Do not swallow the battery, risk of chemical burn. If
the button cell battery in the remote control supplied is
swallowed, it can cause severe internal chemical
burns within 2 hours, which can result in death.
Keep new and used batteries away from children.
If the battery compartment cannot be closed properly,
you must no longer use the remote control, and it must
be kept away from children.
If you think the batteries could have been swallowed
or have gotten into any part of the body, seek medical
help immediately.
WARNING! Risk of material
damage
If you notice any irregularities (e.g. unusual noises,
strange smells or smoke developing), pull the power
unit out of the wall socket immediately. Do not use the
device any longer.
If the device is moved from a cold location to a warm
location, condensate may form in the device. Leave
the device switched off for a few hours.
Place the device on a stable, flat surface.
Protect the device against damage, e.g. from:
- Heat, direct sunlight and open flames
- Impacts and similar violent effects
4
GB
Candles and other open flames must be kept
away from this product at all times in order to
prevent the spread of fire.
Do not cover the power unit to prevent overheating.
Do not use any astringent or abrasive cleaning agents.
The device is fitted with non-slip plastic feet. As furni-
ture is coated with a wide array of varnishes and syn-
thetics, and is also treated with different care products,
it cannot be fully ruled out that some of these materials
contain ingredients that could attack and soften the
non-slip plastic feet. If necessary, place a non-slip mat
under the device.
Please ensure the following when mounting on a wall:
- The fixing material must be matched to the proper-
ties of the wall. If necessary, use fixing material other
than that supplied.
- Make sure that in the installation location there are no
pipes or cables in the wall (e.g. electricity, water, gas).
- If necessary, have the wall mounting carried out by
an expert.
®
Notes on Bluetooth
Radio waves are potentially able to affect or even in-
terfere with the operation of heart pacemakers, (sensi-
tive) electronic devices and other radio waves (e.g.
WLAN). Therefore, please observe the following
notes.
- People wearing heart pacemakers, should maintain
a distance of 20 cm to the product.
- Radio waves may cause interferences, e.g. in mobile
phones or hearing aids.
- Do not use the product in areas subject to explosion
hazards.
- In case of any interferences in other radio units (e.g.
WLAN) occur, check by deenergizing the sound bar
if this is the cause.
- Do not use the device in the vicinity of microwave ov-
ens or devices generating magnetic fields.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

285672

Inhaltsverzeichnis