Before First Use; Daily Use - Zanussi ZDH7332P Benutzerhandbuch

Adjustment of the remaining laundry
moisture degree
To change the default degree of the remaining
moisture of the laundry:
1. Press the on/off button to activate the
appliance.
2. Wait approximately 8 seconds.
3. Press and hold buttons (B) and (D) at the
same time.
One of the these indicators comes on:

Before First Use

Before you use the appliance for the first time
do these operations:
• Clean the tumble dryer drum with a moist
cloth.
• Start a short programme (e.g. 30 minutes)
with moist laundry.

Daily Use

Start a programme without delay start
1. Prepare the laundry and load the appliance.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance
door and the rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for
the type of load.
4. Press the Start/Pause touchpad.
The programme starts.
Starting the programme with delay start
1. Set the correct programme and options for
the type of load.
2. Press the delay start button again and again
as necessary.
You can delay the start of a
programme by 3, 6 or 9 hours.
3. Press the Start/Pause button.
The LEDs (9H, 6H, 3H) change on each 3
hours.
22
• Filter - the maximum dry laundry
• Condenser
• Tank - the standard dry laundry
4. Press the button (E) again and again until
the indicator of the correct level comes on.
5. To confirm the adjustment, press and hold
buttons (B) and (D) at the same time for
approximately 2 seconds.
At the beginning of drying cycle (3-5
min.) there could be a slightly higher
sound level. It is because of start of
the compressor that is normal for
compressor powered appliances
such: refrigerators, freezers.
Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates.
• The indicators Filter and Condenser comes
on.
• The Start/Pause indicator is on.
The appliance continues to operate with the
crease guard phase for approximately other 30
minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when
the phase is almost completed or completed.
When the crease guard phase is completed:
• The indicators Filter and Condenser comes
on.
- the more dry laundry
www.zanussi.com