Open the terminal cover (SD card cover)
A Open the LCD monitor.
B Slide down the terminal cover
lock and slide the cover aside
C Lift the cover slowly.
o To close
.
Leave the LCD monitor open first.
A Flip down the cover slowly while making sure the gray waterproof seal fits into
the opening at the terminals.
B Press the entire cover against the camcorder with equal force and firmly attach
the cover completely.
C Slide the cover until it clicks into place.
(The cover is not properly closed if the red mark at the terminal cover lock is
visible.)
CAUTION
Do not apply excessive force when opening or closing the terminal cover.
0
Do not open or close the terminal cover with wet or dirt/sand-covered hands.
0
Do not allow any dirt, lint, hair, sand, and other foreign substances to
0
accumulate between the waterproof seal and the case.
Never damage or scratch the waterproof seal and terminal cover. Doing so
0
can result in leaks. If the seal is damaged, contact your nearest JVC Service
Center for a replacement. (Charges apply.)
Read the "Detailed User Guide" carefully before using the camcorder under
0
water or in places exposed to water droplet.
Not properly closed if the red mark is visible!
(Rear)
EN
7