Resetting To The Initial State; Device Led Feedback; Flash Codes - HomeMatic HM-LC-Sw4-SM Bedienungsanleitung

9

Resetting to the initial state

In order to reset the actuator to factory status, switch
the device to teach mode with the (first) channel
button (hold button pressed for at least 4 seconds).
If the device is in teach mode, hold the (first)
channel button pressed down for at least 4 seconds.
The actuator reset is indicated by the device LED
flashing quickly.

10 Device LED feedback

10.1 Flash codes

Different actuator states are indicated by the
channel LED/channel LEDs flashing:
Slow flashing
Fast flashing
One long, x-short
(depends on the type
of error)
Teach mode
Reset
Error
57