Preparation Using Ground Coffee; Preparing Milk Froth And Warm Milk - Siemens TE 803 SERIES Gebrauchsanleitung

en
Preparation using
ground coffee
This fully automatic espresso machine can
also be operated using ground coffee (not
instant coffee powder).
Note: The aromaDouble Shot function
cannot be used when coffee is prepared
using ground coffee.
Drink preparation without milk
The appliance must be ready for use.
● Place the pre-warmed cup(s) under the
coffee outlet 9.
● Select the required
Á
by turning the rotary knob 6.
Coffee
● Open the powder compartment 18.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
¡ Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment 18.
● Press the start button 8.
The coffee is brewed and then dispensed
into the cup(s).
Note: Repeat the procedure for another cup
of coffee. If coffee is not dispensed within
90 seconds, the brewing chamber empties
automatically to avoid an overflow. The
appliance rinses.
Drink preparation with milk
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Swivel the coffee outlet 9 to the right until
it clicks into place.
● Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
● Select the required
Cappuccino
Æ
knob 6.
42
À
or
Espresso
or
Macchiato
Å
by turning the rotary
● Open the powder compartment 18.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
¡ Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment 18.
● Press the start button 8.
First milk is delivered into the cup or glass.
Then the coffee is brewed and dispensed
into the cup or glass.
Important: Dried milk residue is difficult
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see "Cleaning the milk system").
Note: Repeat the procedure for another
cup of coffee / milk drink. If coffee is not
dispensed within 90 seconds, the brewing
chamber empties automatically to avoid an
overflow. The appliance rinses.
Preparing milk froth and
warm milk
¡ Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting
or
Warm milk
É
knob 6.
● Press the start button 8.
Milk froth or warm milk flows from the outlet
of the milk frother 10.
Press the start button 8 again to cut the
process short.
Milk froth
by turning the rotary
È