Operating Modes; Exhaust-Air Mode; Circulating-Air Mode - Siemens LC 259BA60 Gebrauchsanleitung Und Montagealeitung

The extractor hood can be used in exhaust
air and circulating air mode. The standard
setting is exhaust air mode.

Exhaust-air mode

The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior by a
pipe system.
Appliance dimensions Exhaust air

Circulating-air mode

The air which is drawn in is cleaned by the
grease filters and an activated carbon filter and
conveyed back into the kitchen.
An activated carbon filter must be installed to
bind odours in circulating-air mode (see
"Removing and installing the grease filters").
The complete installation set as well as the
replacement filters are available from specialist
outlets, customer service or the Online Shop.
The accessory number can be found at the
end of the operating instructions.
Appliance dimensions Circulating air
Switching the electronic control to
circulating air mode
The extractor hood must be connected and
switched off.
Simultaneously press buttons 0 and + until
ã is displayed.
Repeatedly press buttons 0 and + to
switch the electronic control back to exhaust air
mode by (display #).

Operating modes

23