Checking The Battery Charge Level; Checking The Blade Guard; Initial Use; Fitting/Changing The Saw Blade - Parkside PHKSA 18-Li A1 Betriebsanleitung

Removing the battery pack:
♦ Press the release button
battery pack

Checking the battery charge level

GB
♦ Press the battery charge level button
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED
♦ RED/ORANGE/GREEN = maximum charge/
power
RED/ORANGE = medium charge/power
RED = low charge – charge the battery

Checking the blade guard

♦ Pull back on the release lever for the blade
guard as far as the stop.
The blade guard
ming and must spring back into its starting position
automatically when you let go of the release lever
for the blade guard

Initial use

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
release lever
3. Press the spindle lock button
and use the Allen key
screw . Now remove the clamping screw
and the clamping fl ange
Fig. A Changing the saw blade
4. Remove saw blade.
5. Fitting a saw blade
order.
22
and remove the
.
as follows:
must move freely without jam-
.
!
back using the
and put the appliance down.
(until it engages)
to release the clamping
(see also Fig. A).
is carried out in the reverse
6. Press the spindle lock button
and use the Allen key
screw
WARNING!
to
► The arrow on the saw blade
spond to the arrow showing the direction
of rotation (running direction shown on the
appliance).
■ Ensure that the saw blade
rotational speed of the tool.

Rip fence

♦ Loose the wing screw
fence
♦ Set the desired cut width with the help of the
scale on the rip fence
base plate
The right-hand recess in the base plate is for a
cutting angle of 0°. The left-hand recess in the
base plate is for a cutting angle of 45°.
)
Fig. B: Cutting width 3 cm
♦ Retighten the wing screw
Connecting the sawdust extraction
device
♦ Attach the dust extraction adapter
ejector
Optional depending on the diameter of the dust
and sawdust extractor.
♦ Connect an approved dust and chip extraction
device.
(until it engages)
to tighten the clamping
.
is suitable for the
and insert the rip
into the rip fence slot
and the cut out in the
(see also Fig. B).
.
.
PHKSA 18-Li A1
must corre-
.
to the chip