Renkforce POWERPAR 6x8 W Bedienungsanleitung Seite 39

Blackout
Activates or deactivates the blackout function (light off).
Red / Green / Blue / White
Direct selection of the respective colour in full brightness.
+/-
Buttons for setting the parameters or for colour selection in operation with static colours.
When setting the colour in operation with static colours, the colour of the button corresponds to
the colour to be set.
Number buttons 0-9
Buttons for direct input of the start address in DMX operation or for colour selection in operation with
static colours.
When entering single- or two-digit DMX start addresses, it is enough to enter the address in one
or two digits and then wait for approx. three seconds. The value is then accepted automatically.
When setting the colour in operation with static colours, the colour of the button corresponds to
the colour to be set.
Jump
Activates colour change operation.
• Set the effect speed JU01 (low) to JU20 (high) with the buttons +/-.
Fade
Activates fade operation.
• Set the effect speed Fd01 (low) to Fd15 (high) with the buttons +/-.
Color
Activates operation with static colours.
• Set the desired colour with the number buttons 0-9 and the buttons +/-.
The colour of the buttons corresponds to the colour to be set.
Flash
Activates or deactivates the strobe effect in the operating modes "Red / Green / Blue / White", "Jump"
and "Color".
• Set the strobe speed with the buttons +/-.
39