Cancelling A Delay Start; End Of The Washing Programme; Standby Mode; Removing The Load - AEG Electrolux FAVORIT EXPRESS VI Benutzerinformation

– When the countdown is completed, the washing programme starts automatically.
Do not open the door during the countdown to prevent interruption of the countdown.
When you close the door again, the countdown continues from the point of interruption.

Cancelling a delay start

1. Press and hold function buttons B and C until the digital display shows two horizontal
bars.
– When you cancel a delay start, you also cancel the washing programme.
2. Set a new washing programme.

End of the washing programme

• The appliance stops automatically.
• The audible signal for the end of the programme operates.
1. Open the door.
– The digital display shows 0.
– The end-of-programme indicator light comes on.
2. Press the on/off button.
3. For better drying results, keep the door ajar for some minutes before you remove the
dishes.
Let the dishes cool down before you remove them from the appliance. Hot dishes are easily
damaged.
If the save energy function is set, dishes can be wet once the programme finished. We
recommend to leave the appliance door ajar so that dishes can dry naturally.

Standby mode

If you do not switch off the appliance at the end of the washing programme, the appliance
automatically goes into standby mode. The standby mode decreases energy consumption.
Three minutes after the end of the programme, all indicator lights go off and the digital
display shows one horizontal bar. The optical signal goes off.
Press one of the buttons (not the on/off button), to go back to end-of-programme mode.

Removing the load

• First remove items from the lower basket, then from the upper basket.
• There can be water on the sides and door of the appliance. Stainless steel becomes cool
more quickly than the dishes.

Care and cleaning

WARNING!
Switch the appliance off before you clean the filters.
Care and cleaning
21